Projector + Board: Solving the Two-in-One Wall Problem
The projector arrived before anyone planned where it goes. Here are the three layouts that let a screen and a board share one teaching wall.
The everyday conflict
In thousands of classrooms the story is identical: the projector and screen were installed first, and the board was fitted around them later. The result is a screen covering the middle of the board, or a board squeezed into a corner too small to teach from.
Teachers then work around the hardware instead of with it — writing on half a board, or projecting onto a yellowing wall. Both cost learning time every single period.
Layout one: side by side
The simplest fix needs a wall at least 8–10 ft wide: screen on one side, full board on the other. No tracks, no moving parts, works forever. The catch is width — most standard classrooms do not have it.
Layout two, for narrow rooms, is the single-shutter sliding board: the board glides across the screen when writing, and aside when projecting. This is the most-installed layout in smart classrooms across Telangana and Andhra Pradesh today.
Layout three: the full writing wall
For lecture halls, double shutters park at both ends, opening a central screen flanked by writing panels. Closed, they give up to four writing surfaces; open, a full projection theatre.
Whichever layout fits, sequence the work right: measure the wall, decide the layout, then buy the hardware. A ten-minute photo-and-measurement conversation before ordering saves a week of installation-day improvisation.
Board questions? Ask the factory.
Sizes, prices, delivery to your district — we reply within 24 hours.
